Ender 3 with SKR Mini E3 v2.0 Mainboard

SKR-Mini-E3-v2-<date>.bin
 - Enabled CLASSIC_JERK
 - Adds G2 / G3 Arc support
 - Adds G10 / G11 Firmware based retraction (Use M207, M208, M209 to configure)
 - Adds M73 - Set Print Progress
 - Adds M125 - Park Head
 - Adds M412 - Filament Runout sensor on E0-STOP pin (Disable with M412 S0 if you don't have one, Check status with M119, Use the NO pins on your sensor)
 - Adds M600 - Filament Change (10mm extra purge)
 - Adds M701 / M702 - Filament load / upload
 - Adds M900 - Linear Advance - Use this tool to calibrate. Use this video as a guide.
 - Adds TMC Advanced monitoring (M122, M906, M911, M912)
 - Adds M913 - Enabled Hybrid Thresholds
 - FAN_SOFT_PWM enabled to remove fan coil whine of high flow fans
 - Enabled Smart Filament Runout Sensor (Add M412 S0 in your Start G-Code if you do not have a filament sensor).
 - Added support for Meatpack (2020-01-27 onwards)

Important notes for builds 20200718 onwards:
 - Use FAN0 for Part cooling fan
 - Use FAN1 for Hotend fan (will turn on above 50c, off below)
 - Wire the control board fan directly to the supply voltage (this is usually quieter than the hotend fan).

commit 66474f6a1320c8e669a98e699eb819e1c8dd012b
Author: thinkyhead <thinkyhead@users.noreply.github.com>
Date:   Sat Jul 12 06:09:26 2025 +0000

    [cron] Bump distribution date (2025-07-12)

commit 4f0329bb43aed240468d935db8cf2e452c67080f
Author: Scott Lahteine <thinkyhead@users.noreply.github.com>
Date:   Fri Jul 11 20:50:47 2025 -0500

    📝 Update links to Fysetc Mini12864_Panel